Mixer heater
For 2K materials, we do not heat the 2K cartridges but rather target the mixing tube. This ensures that only the dispensed material is heated, preventing continuous heating of the entire material.
Some adhesives are sensitive to heat, as it affects their curing time. Prolonged heating can cause them to gradually harden.
Since the mixing tube presents a higher resistance, it is more effective to lower the viscosity by applying heat at this point. The mixing tube heater acts like a small instant heater, warming only the adhesive being dispensed.
5034 Mixer heating
Tempering high-viscosity 2K media can be useful to improve flowability and achieve a clean break-off.
Heating reduces viscosity, which facilitates processing and improves dosing quality.
Temperature range: 0 – 60 °C.
Temperature sensor: PT 100 for precise measurement.
Temperature control: +/- 2 °C (accurate control of heating temperature).
Connection cable length: 140 cm.
Connection to heating control unit: 9-pin Sub-D connector.
9320 Cartridge Heater – 310 ml
-
Electric heating sleeve for 310-ml plastic or metal cartridges; compatible with axiss pressure vessels Ø 55 mm.
-
Even heating lowers viscosity and stabilizes volumetric dispensing.
-
Controlled via temperature controller Art. 4500 with digital setpoint entry and set/actual display (230 V / 180 W, 0–80 °C, ±2 °C).
-
Recommended preheat time: 20–30 minutes until the material is at temperature.
